Unsteady Jeffrey Fluid Flow, Heat and Mass Transfer Along a Stretching Cylinder with Arrhenius Activation Energy

Authors

  • Muhammad Ali Department of Mathematical Sciences, University of Engineering and Technology (UET) Taxila, Pakistan
  • Azeem Shahzad Department of Mathematical Sciences, University of Engineering and Technology (UET) Taxila, Pakistan

DOI:

https://doi.org/10.54938/ijemd-m.2026.04.1.933

Keywords:

Jeffrey fluid; Stretching cylinder; Arrhenius activation energy.

Abstract

In the present work, the unsteady flow, heat transfer and mass transfer of a Jeffrey fluid over a stretching cylinder has been formulated. There is a modified Arrhenius reaction in the concentration equation and the concentration reaction-heat contribution to the energy equation. The conservation laws are mapped to a coupled, 8th order boundary value problem which is integrated numerically with MATLAB code bvp4c and compared to 2 independent Newtonian benchmarks within 4×〖10〗^(-4). The next parameter sweep shows a clean separation of the parameters which influence the model, namely the skin-friction coefficient is only sensitive to the curvature, the unsteadiness and the two Jeffrey parameters, the momentum equation has no feedback on the thermal and concentration field, and the thermal and concentration field is sensitive to the other nine parameters. Of these, activation energy is the most influential, and is able to reduce the Sherwood number by nearly 25% of the range tested, whereas the Schmidt number is able to more than double the Sherwood number. The analysis reveals that the higher the curvature parameter and the Deborah number, the higher the rates of heat and mass transfer; however, the higher the ratio of relaxation-to-retardation time, the lower the rates of heat and mass transfer, and that this is a design parameter which a flat-plate treatment cannot offer.

Downloads

Download data is not yet available.

References

B. C. Sakiadis, “Boundary-layer behavior on continuous solid surfaces: II. The boundary layer on a continuous flat surface,” AIChE Journal, vol. 7, no. 2, pp. 221–225, 1961.

L. J. Crane, “Flow past a stretching plate,” Zeitschrift für Angewandte Mathematik und Physik, vol. 21, no. 4, pp. 645–647, 1970.

L. J. Grubka and K. M. Bobba, “Heat transfer characteristics of a continuous, stretching surface with variable temperature,” Journal of Heat Transfer, vol. 107, no. 1, pp. 248–250, 1985.

M. E. Ali, “Heat transfer characteristics of a continuous stretching surface,” Wärme- und Stoffübertragung, vol. 29, no. 4, pp. 227–234, 1994.

C. Y. Wang, “Fluid flow due to a stretching cylinder,” Physics of Fluids, vol. 31, no. 3, pp. 466–468, 1988.

A. Ishak and R. Nazar, “Laminar boundary layer flow along a stretching cylinder,” European Journal of Scientific Research, vol. 36, no. 1, pp. 22–29, 2009.

A. Ishak, R. Nazar, and I. Pop, “Unsteady mixed convection boundary layer flow due to a stretching vertical surface,” Arabian Journal for Science and Engineering, vol. 31, no. 2, 2006.

T. Hayat, Z. Iqbal, M. Mustafa, and A. Alsaedi, “Unsteady flow and heat transfer of Jeffrey fluid over a stretching sheet,” Thermal Science, vol. 18, no. 4, pp. 1069–1078, 2014.

T. Hayat, S. Asad, A. Alsaedi, and F. E. Alsaadi, “Radiative flow of Jeffrey fluid through a convectively heated stretching cylinder,” Journal of Mechanics, vol. 31, no. 1, pp. 69–78, 2015.

M. Imtiaz, T. Hayat, and A. Alsaedi, “MHD convective flow of Jeffrey fluid due to a curved stretching surface with homogeneous–heterogeneous reactions,” PLOS ONE, vol. 11, no. 9, Art. no. e0161641, 2016.

K. U. Rehman, A. A. Khan, M. Y. Malik, and O. D. Makinde, “Thermophysical aspects of stagnation point magneto-nanofluid flow yields by an inclined stretching cylindrical surface: A non-Newtonian fluid model,” Journal of the Brazilian Society of Mechanical Sciences and Engineering, vol. 39, pp. 3669–3682, 2017.

T. Hayat, S. Qayyum, M. Farooq, A. Alsaedi, and M. Ayub, “Mixed convection flow of Jeffrey fluid along an inclined stretching cylinder with double stratification effect,” Thermal Science, vol. 21, no. 2, pp. 849–862, 2017.

D. J. Samuel, K. S. Adegbie, and A. J. Omowaye, “Significance of non-uniform heat generation and convective boundary conditions in heat and mass transfer flow of Jeffrey fluid in the presence of Arrhenius activation energy and binary reaction,” The European Physical Journal Special Topics, vol. 232, no. 6, pp. 877–891, 2023.

M. Jawad, A. B. M. Ali, W. Abdelfattah, and G. Bognár, “Numerical modelling of heat transfer and flow efficiency in the stretching process and extrusion of Jeffrey fluid in a heated cylinder,” International Journal of Thermofluids, vol. 29, Art. no. 101395, 2025.

M. Jawad, A. B. M. Ali, A. Majeed, N. S. S. Singh, A. K. A. Jawwad, H. A. Garalleh, and I. Mahariq, “Significance of Cattaneo–Christov heat flux and bioconvection in magnetized Jeffrey nanofluid inside an extendable cylinder: Advances in cooling system,” Results in Engineering, vol. 30, Art. no. 110094, 2026.

J. Kierzenka and L. F. Shampine, “A BVP solver based on residual control and the MATLAB PSE,” ACM Transactions on Mathematical Software, vol. 27, no. 3, pp. 299–316, 2001.

T.-G. Fang, J. Zhang, Y.-F. Zhong, and H. Tao, “Unsteady viscous flow over an expanding stretching cylinder,” Chinese Physics Letters, vol. 28, no. 12, Art. no. 124707, 2011.

C. Y. Wang, “Free convection on a vertical stretching surface,” ZAMM—Journal of Applied Mathematics and Mechanics, vol. 69, no. 11, pp. 418–420, 1989.

Downloads

Published

2026-11-21

Issue

Section

Research Article

Categories

How to Cite

Unsteady Jeffrey Fluid Flow, Heat and Mass Transfer Along a Stretching Cylinder with Arrhenius Activation Energy. (2026). International Journal of Emerging Multidisciplinaries: Mathematics, 4(1). https://doi.org/10.54938/ijemd-m.2026.04.1.933